Allied Telesis AT 8000/8POE - Manual (Page 128)

Chapter 9: Virtual LANs and GVRP
128 Section I: Using the Menus Interface
Modifying a
VLAN
The topics in this section include:
Before performing this procedure, note the following:
 You cannot change the VID of a VLAN.
 You cannot add an untagged port to a VLAN with this
procedure. That function requires changing a port’s
VID value, as explained in “Configuring the Port PVID”
on page 124
 You cannot remove an untagged port from a VLAN
with this procedure. To remove an untagged port from
a VLAN, you must assign it as an untagged member of
another VLAN by changing its PVID, as explained in
“Configuring the Port PVID” on page 124.
Changing the VLAN Name
To change the name of a VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 87.
2. From the Advanced Switch Configuration Menu, type V to select
VLAN Management.
The VLAN Management Menu is shown in Figure 29 on page 122.
3. Type O to select Config VLAN Member.
The following prompt is displayed:
Enter VLAN ID >
Enter the number of the VLAN you want to modify.
The Config VLAN Member menu is shown in Figure 31 on page 127.
4. Type C to select Change VLAN Name.
The following prompt is displayed:
Enter new VLAN name>
5. Enter the new name for the VLAN. A VLAN name can be up to 32
characters and can include spaces.
Adding or Removing a Tagged Port in a VLAN