Allied Telesis AT 8000/8POE - Manual (Page 109)

AT-S81 Management Software User’s Guide
Section I: Using the Menus Interface 109
3. Type U to change the status to Up (online), or type D to change the
status to Down (offline).
Setting the PoE
Port’s Priority
The priority defines which port and its attached PoE powered device
should receive priority for the available power over other PoE devices. For
more information about port priority, refer to “Port Prioritization for Power
Allocation” on page 105.
To set the port priority, perform the following procedure:
1. Type I to select Set PoE Port Priority.
The following prompt is displayed:
Enter port number >
2. Enter the number of the port you whose priority you want to change.
The following prompt is displayed:
Enter the selection (L/H/C) >
3. Type one of the following:
L - To change the port priority to low. This is the default.
H - To change the port priority to high.
C - To change the port priority to critical, so that this device
continues to receive power even if others do not.