Allied Telesis AT 8000/8POE - Manual (Page 265)

AT-S81 Management Software User’s Guide
Section II: Web Browser Interface 265
Setting Up an LACP Trunk
This section contains the following procedures:
 “Creating an LACP Trunk,” next
 “Configuring the LACP Port Priority” on page 266
 “Viewing the LACP Group Settings” on page 267
 “Disabling an LACP Trunk” on page 267
Note
Create the trunk before you make it an LACP trunk. For more
information, see “Setting Up a Port Trunk” on page 262.
Creating an
LACP Trunk
To create an LACP trunk, perform the following procedure:
1. From the Advanced Config menu, select Trunk Config > Trunk
Config.
The Trunk Configuration page is shown in Figure 77.
2. On the row that corresponds to the trunk you want to enable as an
LACP trunk, from the list, choose one of the following settings:
Active - LACP Active: Ports are in an active negotiation state.
Passive - LACP Passive: Ports are in a passive state where the port
negotiates a bundle by exchanging LACP packets to the peer only if
the far end initiates it.
Note
LACP must be enabled at both ends of the link to be operational.
3. Click Apply.