Allied Telesis SwitchBlade x3106 - Manual (Page 86)

Chapter 3: Installing the Chassis on a Table or in an Equipment Rack
86
Figure 38. Turning the Chassis Upside Down
2. Using a flat-head screwdriver, pry the rubber feet from the bottom of
the chassis, as shown in Figure 39.
Figure 39. Removing the Rubber Feet
3. Turn the chassis over.
Go to the next procedure, ”Adjusting the Equipment Rack Brackets”.
Adjusting the
Equipment Rack
Brackets
You may change the positions of the two pre-installed equipment rack
brackets so that the front of the chassis is flush with, extends beyond, or is
recessed behind the front of the equipment rack. You may also install the
chassis so that the rear panel is flush with the front of the equipment rack.
The different bracket positions are listed in Table 24 on page 87 and
illustrated in Figure 40 on page 88 and Figure 41 on page 88. Please
review the following information before moving the brackets:
 Position A, the default position, positions the chassis so that the
front of the unit is flush with the front of the equipment rack.
 Position B recesses the front of the chassis by 27.39 mm (1.1 in).
 Positions C to E extend the front of the chassis beyond the front of
the rack from 27.39 mm (1.1 in) to 140.85 mm (5.545 in).