Allied Telesis SwitchBlade x3106 - Manual (Page 199)

SwitchBlade x3106 Installation Guide
199
 Data bits: 8
 Parity: None
 Stop bits: 1
 Flow control: None
Note
The port settings are for a DEC VT100 or ANSI terminal, or an
equivalent terminal emulator program.
4. Press Enter. You are prompted for a user name and password.
5. Enter the default user name and password. They are “manager” and
“friend” (without the quotes), respectively
Note
User names and passwords are case sensitive.
The local management session starts and the command line interface
(CLI) prompt is displayed.
Entering the
Management
Software
Commands
To confirm the operations of the chassis with the commands in the
management software, perform the following procedure:
1. Enter the SHOW SYSTEM command to display the software version
number of the management software on the control card, as shown in
Figure 148.
Figure 148. SHOW SYSTEM Command
2. Compare the version number displayed by the SHOW SYSTEM
command with the information in Table 23 on page 69 to confirm that
the management software on the control card supports all the
hardware components in the chassis. If necessary, update the
management software on the control card. For example, if the control
card has release 17.0 and the chassis has line cards that require a
newer release, the cards will not forward network packets until you
SHOW SYSTEM
--- System Information ----------------------------------------------
System Date.................. 2013-02-21
System Uptime................ 2 days, 14 hours, 27 minutes, 18 seconds
Software
Version.................. 17.0.0
Options ................. Customer-Release Build
Created ................. Wed 02/8/2013 at 1:25 PM
Boot From ................... preferred
Software Version
Number