Allied Telesis SwitchBlade x3106 - Manual (Page 164)

Chapter 7: Powering On the Chassis
164
Powering on the AT-SBxPWRPOE1 AC Power Supply
This section contains instructions on how to power on the AT-
SBxPWRPOE1 AC Power Supply. For installation instructions, refer to
“Installing the AT-SBxPWRPOE1 AC Power Supply” on page 103. To
power on the power supply, perform the following procedure:
1. Identify AC sockets A and B in the recessed panel on the back panel
of the chassis, shown in Figure 110 on page 161. The sockets are for
the AT-SBxPWRPOE1 Power Supplies in slots A and B on the front
panel of the chassis.
2. Plug the AC power cord that comes with the power supply into a plug
whose corresponding slot on the front panel has a PoE power supply.
If there are two PoE power supplies, you may power on either supply
first. The illustration in Figure 113 shows the AC power cord being
connected to connector A for the power supply in slot A on the front
panel.
Figure 113. Connecting the AC Power Cord for the AT-SBxPWRPOE1
Power Supply