Allied Telesis SwitchBlade x3106 - Manual (Page 175)

SwitchBlade x3106 Installation Guide
175
Figure 127. Attaching the Power Wires to the Power Terminal Lugs
3. Verify that the On/Off switch on the AT-SBxPWRSYS1 DC Power
Supply is in the Off position. Refer to Figure 128.
Figure 128. On/Off Switch On the AT-SBxPWRSYS1 DC Power Supply
4. Use a #1 Phillips-head screwdriver to loosen the two screws on the
plastic cover over the positive and negative terminals on the power
supply and slide the cover to the right, as shown in Figure 129 on page
176. You may need to lift the locking handle slightly to access the
bottom screw.
On/Off Switch