Allied Telesis SwitchBlade x3106 - Manual (Page 116)

Chapter 5: Installing the AT-SBx31CFC Card and Ethernet Line Cards
116
Guidelines to Handling the Controller and Line Cards
Please observe the following guidelines when handling the controller and
Ethernet line cards:
 The cards are hot swappable and can be installed or removed
while the chassis is powered on.
 Always wear an anti-static device when handling the cards.
Caution
The electronic components on the controller and line cards can be
damaged by electro-static discharges (ESD). Follow the procedure
in “Protecting Against Electrostatic Discharge (ESD)” on page 90 to
guard against ESD damage when unpacking and installing the line
cards.
 Hold a card by its faceplate or edges.
 Never touch the electronic components on the top or bottom of a
card.
 To avoid damaging the components on the bottom of a card, do
not set it down on a table or desk. If you need to set down a card,
return it to its anti-static bag and packaging container.
 Do not remove a card from its anti-static bag until you are ready to
install it in the chassis.
 If you need to remove a card from the chassis, immediately return
it in its anti-static bag and packaging container.
 Never hold or lift a controller card by the handles on the front
faceplate. You might bend or damage the handles.
Caution
Keep a card level as you slide it into or out of the chassis. You might
damage the components on the top or bottom of a card if you slide it
at an angle. Refer to Figure 70 on page 117.