Figure 137: removing the plastic cover – Allied Telesis SwitchBlade x3106 User Manual

Page 182

Text mode
Original mode

Chapter 7: Powering On the Chassis

182

4. Using a #1 Phillips-head screwdriver, remove the two screws that

secure the plastic cover over the positive and negative terminals and
remove the plastic cover from the power supply, as shown in
Figure 137. You may need to lift the locking handle slightly to access
the bottom screw.

Figure 137. Removing the Plastic Cover

Note

The plastic cover is not used with the right angle terminals.

5. Use a #3 Phillips-head screwdriver to remove the two screws from the

positive and negative terminals, as shown in Figure 138 on page 183.