Allied Telesis SwitchBlade x3106 - Manual (Page 201)

SwitchBlade x3106 Installation Guide
201
An example of the status information is shown in Figure 151. A card is
operating normally when its state is UP-UP-ONLINE. If there is a
problem with a card, refer to “Ethernet Line Cards” on page 207 or “AT-
SBx31CFC Controller Fabric Card” on page 215 for troubleshooting
suggestions.
Figure 151. SHOW CARD Command
6. To check the status of PoE on the ports of the AT-SBx31GP24 Line
Card, use the SHOW POE INTERFACE=ALL command.
Ports that are delivering power to powered devices have the value
Powered in the Power Status column of the display. If there is a
problem, refer to “Power Over Ethernet” on page 211 for
troubleshooting suggestions.
For information about the command line interface, refer to the Software
Reference for SwitchBlade x3100 Series Switches on the Allied
Telesis web site.
SHOW CARD
--- Card Information ---
Prov
Slot Card Type State Faults
---- --------- ------------------- ------
0 GE24RJ UP-UP-Online -
1 GE24RJ UP-UP-Online -
2 GE24RJ UP-UP-Online -
3 GE24RJ UP-UP-Online -
4 CFC200 UP-UP-Online (Inactive) -
5 CFC200 UP-UP-Online (Active) -