Allied Telesis SwitchBlade x3106 - Manual (Page 148)

Chapter 6: Installing the Transceivers and Cabling the Ports
148
5. Connect the fiber optic cable to the port on the transceiver, as shown
in Figure 101. The connector should snap into the port.
Figure 101. Attaching a Fiber Optic Cable to an SFP+ Transceiver in the
AT-SBx31XS6 Line Card
6. Repeat this procedure to install additional SFP plus transceivers in the
AT-SBx31XS6 Line Cards.
After installing and cabling the SFP+ transceivers, do one of the following:
 To install and cable additional transceivers, go to the appropriate
section in this chapter for instructions.
 After cabling all the ports in the chassis, go to Chapter 7,
“Powering On the Chassis” on page 159.