Allied Telesis SwitchBlade x3106 - Manual (Page 227)

SwitchBlade x3106 Installation Guide
227
Figure 157. Loosening the Screw on the Locking Handle
Note
If the power wires are connected to the terminal block with the right
angle terminals, go to step 5.
4. Use a #1 screwdriver to loosen the two screws that secure the plastic
cover over the terminal block and slide the cover to the right. You may
need to slightly lift the locking handle to access the bottom screw.
Refer to Figure 158 on page 228.
The plastic cover may not be present if the lead wires are connected to
the terminal block with the right angle terminals. If this is the case, you
may skip this step.