Allied Telesis SwitchBlade x3106 User Manual

Page 240

Text mode
Original mode

Chapter 10: Replacing Modules

240

4. At the command prompt, enter the ENABLE CARD command to

enable the slot with the new card. For example, to enable the Ethernet
line card in slot 1, you enter:

enable card=1

5. Log off to end your management session.

6. Connect the network cables to the new line card. For instructions, refer

to Chapter 6, “Installing the Transceivers and Cabling the Ports” on
page 131.

If you are not replacing the line card at this time, you should cover the slot
with a blank cover. For instructions, refer to “Installing the Blank Slot
Covers” on page 128.

If you do not plan to install the removed line card in another slot or
chassis, store the card in an anti-static bag and return it to its shipping
container.