Allied Telesis SwitchBlade x3106 - Manual (Page 78)

Chapter 2: Safety Precautions and Site Preparation
78
Installation Tools and Material
Here is a list of tools and material you need to supply to install the product:
Here are the required items for installing the chassis in an equipment rack:
 #2 Phillips-head screwdriver
 Six equipment rack screws
 Flat-head screwdriver
 #2 Phillips-head 10 inch-lbs torque screwdriver (optional)
Here are the required items for installing the grounding wire:
 #2 Phillips-head screwdriver
 Crimping tool (not provided)
 10 AWG stranded grounding wire
 #2 Phillips-head 20 inch-lbs torque screwdriver (optional)
Here are the items for installing the AT-SBxPWRSYS1 DC Power Supply:
 Two 8 AWG power wires
 One 10 AWG stranded grounding wire
 8 mm wrench
 #1 Phillips-head screwdriver
 #3 Phillips-head screwdriver
 #3 Phillips-head 30 to 40 inch-lbs torque screwdriver (optional)
Here are the items for installing the AT-SBx31CFC Central Fabric
Controller card and Ethernet line cards:
 #2 Phillips-head screwdriver
 #2 Phillips-head, 5 inch-lbs torque screwdriver (optional)