HP 3PAR Operating System Software - Manual (Page 62)

6. Define a second target system (for example, the synchronous backup system SystemB) for the
current backup system. On the current backup system (SystemC), issue the following command:
For RCFC
# creatercopytarget FC : :
where:
•
—Name of the remote-copy target system (SystemB)
•
FC —Specifies an FC link
•
—WWN of the target node (SystemB)
•
: —FC adapter port on the backup system (SystemC), expressed as
node:slot:port, and the WWN of the peer port of the target system (SystemB)
For RCIP
# creatercopytarget IP : :
where:
•
—Name of the remote-copy target system (SystemB).
•
IP —Specifies an IP link.
•
: —Node on SystemC that contains the IP connections to the target
system, expressed as node:slot:port, and the IP address for the target system (SystemB)
(2:4:1:10.100.33.195 and 3:4:1:10.101.33.195).
SLD Remote-Copy Example
The setup steps for SLD configuration refer to the setup illustrated in Figure 21 (page 63) .
The figure shows:
•
Synchronous remote copy between SystemA and SystemB
•
Asynchronous periodic remote copy between SystemA and SystemC
•
Asynchronous periodic remote copy between SystemB and SystemC
62 Setting Up SLD Remote Copy