HP 3PAR Operating System Software - Manual (Page 215)

Target Node Address Status Options
SystemA 0 10.100.33.96 Up
SystemA 1 10.101.33.96 Up
SystemB 0 10.100.33.195 Up
SystemB 1 10.101.33.195 Up
receive 0 receive Up
receive 1 receive Up
Group Information
Name Target Status Role Mode Options
multi.1.r96 SystemA Backup Secondary Periodic Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 300 testvv.0 100 Synced 2009-06-29 12:31:44 PDT
testvv.1 301 testvv.1 101 Synced 2009-06-29 12:31:47 PDT
testvv.2 302 testvv.2 102 Synced 2009-06-29 12:31:45 PDT
testvv.3 303 testvv.3 103 Synced 2009-06-29 12:31:45 PDT
Name Target Status Role Mode Options
multi.1.r96 SystemB Started Secondary Periodic Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 300 testvv.0 200 Synced 2009-06-29 12:32:26 PDT
testvv.1 301 testvv.1 201 Synced 2009-06-29 12:32:28 PDT
testvv.2 302 testvv.2 202 Synced 2009-06-29 12:32:27 PDT
testvv.3 303 testvv.3 203 Synced 2009-06-29 12:32:27 PDT
Solution Problem
I/O to the volumes on the
failover system did not stop
before the synchronization. 1. Stop I/O.
2. Manually synchronize the remote-copy pair. On the failover system (SystemB),
enter either of the following commands:
syncrcopy
where represents the reversed volume group (multi.1.r96)
or:
syncrcopy -pat
where -pat represents the pattern of reversed volume group
names (multi*)
4. To verify that the volume groups are started, issue the following command on the recovered
system (SystemA):
# showrcopy groups
where represents the volume group that should be started (multi.1).
Solution Problem
The volume groups are not
started. 1. On the recovered system, issue either of the following commands:
startrcopygroup
or:
startrcopygroup -pat
where -pat represents the pattern of volume group names (for
example, multi*).
2. Wait for the synchronizations to complete before continuing.
Failing Over to the Synchronous Backup System 215