HP 3PAR Operating System Software - Manual (Page 253)

Quick Setup: RCIP Transport Layer
Table 8 Quick Setup Steps for RCIP
Backup System Primary System Reference Step
controlport rcip addr
[-f]
controlport rcip
addr [-f]
“Setting Up the Remote-Copy
Interface for RCIP” (page 30) 1. On all RCIP ports, set up
the interface.
controlport rcip gw
[-f]
controlport rcip gw
[-f]
“Setting the Gateway”
(page 31) 2. On all RCIP ports, set the
gateways.
showport -rcip showport -rcip “ 3. Verify gateway IPs.
controlport rcip ping controlport rcip
ping
“Verifying That the Servers
Are Connected” (page 32) 4. Verify connectivity.
a. cli checkrclink
startserver
“Checking RCIP Link
Throughput and Latency”
(page 33) 5. On all nodes and
systems, check the links.
b. cli checkrclink
startclient
c. cli checkrclink
stopserver
showport -rcip showport -rcip “Increasing MTU” (page 33) 4. Verify gateway IPs.
5. (If possible) On each
port, increase MTU.
controlport rcip ping
-s 8972 -pf
controlport rcip
ping -s 8972 -pf
“ 6. (If MTU increased) On
each port, verify MTU
support.
Quick Setup: RCIP Transport Layer 253