HP 3PAR Operating System Software - Manual (Page 197)

b. Verify that for the target (recovered) system (System1):
•
the Status of the target system is ready
•
the Status of all sending links is Up
•
the SyncStatus of all volumes in the Primary-Rev volume groups is Syncing
(or Synced)
The following example shows the showrcopy command output for System2:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System1 7 IP ready mirror_config
Link Information
Target Node Address Status Options
System1 0 10.100.33.96 Up
System1 1 10.101.33.96 Up
receive 0 10.100.33.96 Up
receive 1 10.101.33.96 Up
Group Information
Name Target Status Role Mode Options
periodic_group_1.r96 System1 Started Primary-Rev Periodic Last-Sync Thu Dec 14 18:39:03 PST
2006 , over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
remotevv.0 21 localvv.0 413 Syncing (40%) Thu Dec 14 18:23:52 PST 2006
remotevv.1 22 localvv.1 414 Syncing (50%) Thu Dec 14 18:39:03 PST 2006
c. Issue the showrcopy command on the recovered system (System1).
d. Verify the following:
•
The Status of the target system (System2) is ready
•
The Status of all sending links is Up
•
The Role of the synchronizing volume groups is Secondary-Rev
•
The SyncStatus of all volumes in the Secondary-Rev volume groups is Synced
The following example shows the showrcopy command output for System1:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System2 11 IP ready mirror_config
System3 12 IP ready mirror_config
Link Information
Target Node Address Status Options
System2 0 10.100.33.61 Up
Disaster Recovery for 1-to-N Configurations 197