HP 3PAR Operating System Software - Manual (Page 214)

The following example shows the showrcopy command output for SystemA:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemB 58 FC ready 2FF70002AC0000C3 mirror_config
SystemC 59 IP ready mirror_config
Link Information
Target Node Address Status Options
SystemB 0:2:1 20210002AC0000C3 Up
SystemB 1:2:1 21210002AC0000C3 Up
SystemC 0:3:1 10.100.33.63 Up
SystemC 1:3:1 10.101.33.63 Up
receive 0:2:1 20210002AC0000C3 Up
receive 1:2:1 21210002AC0000C3 Up
receive 0:3:1 receive Up
receive 1:3:1 receive Up
Group Information
Name Target Status Role Mode Options
multi.1 SystemB Started Secondary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 100 testvv.0 200 Synced NA
testvv.1 101 testvv.1 201 Synced NA
testvv.2 102 testvv.2 202 Synced NA
testvv.3 103 testvv.3 203 Synced NA
Name Target Status Role Mode Options
multi.1 SystemC Backup Secondary-Rev Periodic Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 100 testvv.0 300 Synced 2009-06-29 12:32:26 PDT
testvv.1 101 testvv.1 301 Synced 2009-06-29 12:32:28 PDT
testvv.2 102 testvv.2 302 Synced 2009-06-29 12:32:27 PDT
testvv.3 103 testvv.3 303 Synced 2009-06-29 12:32:27 PDT
e. Issue the showrcopy command on the asynchronous periodic backup system (SystemC).
f. Verify the following:
•
The Status of the primary system (SystemA) is ready.
•
The Status of the primary system’s sending links (SystemA) is Up.
The following example shows the showrcopy command output for SystemC:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemA 42 IP ready mirror_config
SystemB 44 IP ready mirror_config
Link Information
214 Disaster Recovery for SLD Configurations