HP 3PAR Operating System Software - Manual (Page 222)

3. Verify that the newer data is being pushed to the failover system.
a.
While remote copy progresses through the failover tasks, issue the showrcopy command
on the synchronous backup system (SystemB).
The following example shows the showrcopy command output for SystemB:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
SystemA 46 FC failed 2FF70002AC000060 mirror_config
SystemC 47 IP ready mirror_config
Link Information
Target Node Address Status Options
SystemA 0:2:1 20210002AC000060 Down
SystemA 1:2:1 21210002AC000060 Down
SystemC 0:4:1 10.100.33.63 Up
SystemC 1:4:1 10.101.33.63 Up
receive 0:2:1 20210002AC000060 Up
receive 1:2:1 21210002AC000060 Up
receive 0:4:1 receive Up
receive 1:4:1 receive Up
Group Information
Name Target Status Role Mode Options
multi.1.r96 SystemA Stopped Primary-Rev Sync
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 100 Stopped 2009-06-29 14:33:12 PDT
testvv.1 201 testvv.1 101 Stopped 2009-06-29 14:33:12 PDT
testvv.2 202 testvv.2 102 Stopped 2009-06-29 14:33:12 PDT
testvv.3 203 testvv.3 103 Stopped 2009-06-29 14:33:12 PDT
Name Target Status Role Mode Options
multi.1.r96 SystemC Started Primary-Rev Periodic Last-Sync 2009-06-29 14:39:04 PDT ,
Period 5m, over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
testvv.0 200 testvv.0 300 Syncing (0%) 2009-06-29 14:32:01 PDT
testvv.1 201 testvv.1 301 Syncing (0%) 2009-06-29 14:32:05 PDT
testvv.2 202 testvv.2 302 Syncing (0%) 2009-06-29 14:32:03 PDT
testvv.3 203 testvv.3 303 Syncing (0%) 2009-06-29 14:32:02 PDT
b. Issue the showrcopy command on the asynchronous periodic backup system (SystemC).
For example, SystemC output looks like the following:
222 Disaster Recovery for SLD Configurations