HP 3PAR Operating System Software - Manual (Page 60)

2. Define a target (for example, the primary system SystemA) on the backup system. On the
backup system (SystemB), issue the following command:
•
For RCFC:
# creatercopytarget FC : :
where:
◦ —Name of the remote-copy target system (SystemA).
◦
FC —Specifies a FC link.
◦ —WWN of the target node (node 2FF70002AC000060 on SystemA).
◦
: —FC adapter port on the backup system (SystemB), expressed as
node:slot:port, and the WWN of the peer port on the target system (SystemA)
(0:1:1:20110002AC000060 and 1:3:2:21320002AC000060).
•
For RCIP:
# creatercopytarget IP : :
where:
◦ —Name of the remote-copy target system (SystemA).
◦
IP —Specifies an IP link.
◦
: —Node on the backup system (SystemB) that contains the IP
connections to the target system, expressed as node:slot:port, and the IP address for
the target system (SystemA) (2:4:1:10.100.33.96 and 3:4:1:10.101.33.96).
3. Define a second target system (for example, the asynchronous periodic backup system SystemC)
for the backup system. On the backup system (SystemB), issue the following command:
For RCFC
# creatercopytarget FC : :
where:
•
—Name of the remote-copy target system (SystemC)
•
FC —Specifies an FC link
•
—WWN of the target node (SystemC)
•
: —FC adapter port on the backup system (SystemB), expressed as
node:slot:port, and the WWN of the peer port of the target system (SystemC)
For RCIP
# creatercopytarget IP : :
60 Setting Up SLD Remote Copy