HP 3PAR Operating System Software - Manual (Page 255)

Quick Setup: Unidirectional Remote Copy
Table 10 Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1, and 1-to-N Configurations
Backup System Primary System Reference Step
— startrcopy “Setting Up the Primary
System for Unidirectional
Remote Copy” (page 78) 1. Start remote copy.
— RCIP:
creatercopytarget “Setting Up the Primary
System for Unidirectional
Remote Copy” (page 78)
2. Define a target.
IP
:
RCFC:
creatercopytarget
FC
startrcopy — “Setting Up the Backup
System for Unidirectional
Remote Copy” (page 79) 3. Start remote copy.
RCIP:
creatercopytarget — “Setting Up the Backup
System for Unidirectional
Remote Copy” (page 79)
4. Define a target.
IP
:
RCFC:
creatercopytarget
FC
showrcopy showrcopy “Checking the Links between
Systems for Unidirectional
Remote Copy” (page 80) 5. Check the links between
systems.
Create virtual volumes that
are the same size as the Create virtual volumes. 6. Ensure that virtual
volumes exist and can be
used with remote copy. • “Verifying That Virtual
Volumes Are Created for
Unidirectional Remote
Copy” (page 81)
volumes on the primary
system.
•
HP 3PAR OS CLI
Administrator’s Manual
— creatercopygroup
:
“Creating Volume Groups
for Unidirectional Remote
Copy” (page 82) 7. Create volume groups.
— setrcopygroup period
s|m|h|d
“Creating Volume Groups
for Unidirectional Remote
Copy” (page 82)
8. (Optional, asynchronous
periodic mode only) Set
up automatic
synchronization.
— admitrcopyvv “Creating Volume Groups
for Unidirectional Remote
Copy” (page 82)
9. Add the virtual volumes
to their volume groups.
— — “Selecting an Initial
Replication Method for 10. Decide the method to use
for the first replication of
data.
Unidirectional Remote
Copy” (page 84)
“Using Tape for Initial
Synchronization and
Backup” (page 151) • If using tape for data
transfer:
Quick Setup: Unidirectional Remote Copy 255