Manually resynchronizing volume groups – HP 3PAR Operating System Software User Manual
Page 115
where
3.
To start the primary volume group, issue either of the following commands:
# startrcopygroup
or:
# startrcopygroup -pat
where
Group*
).
4.
If the volume group’s new mode is asynchronous periodic, set a synchronization period by
issuing either of the following commands:
# setrcopygroup period
where:
•
—Resynchronization period (time span between start of resynchronizations)
and time unit (seconds, minutes, hours, or days)
•
—Name of the backup system for the volume group you are changing
•
—Name of the primary volume group
or:
# setrcopygroup period
where
CAUTION:
You must specify a synchronization period. HP 3PAR Remote Copy does not
have a default synchronization period, so if you do not set a synchronization period,
remote-copy volume groups will not be automatically resynchronized.
Manually Resynchronizing Volume Groups
To resynchronize primary and secondary volume groups manually, consider the mode being used.
Manually Resynchronizing Volume Groups
115