HP 3PAR Operating System Software - Manual (Page 35)

Figure 12 Network and RCFC Setup
To configure an RCFC transport layer, use the worksheet in Figure 13 (page 35)
Figure 13 Network and RCFC Setup Information—Example Worksheet
Configuring Ports for RCFC
For RCFC configurations, each link between a remote-copy pair is a physical link between a
controller node on one storage system and a controller node on the other storage system in the
pair. These links use up to four 8 GB/s FC adaptor ports from each of the nodes in the storage
systems that belong to the remote-copy pair.
If these ports were not set up during the initial setup of the storage system, or if the configuration
has changed, reconfigure the ports before you set up the remote-copy transport layer.
Setting Up Remote Copy over Fibre Channel 35