HP 3PAR Operating System Software - Manual (Page 114)

Figure 35 Volume Mapping between Bidirectional Primary and Backup Systems
Changing the Remote-Copy Mode for a Volume Group
For most remote-copy configurations, you can have only one mode per target system, synchronous
or asynchronous periodic, for all primary volume groups on the primary system.
1.
Stop the primary volume group on the primary system. (Resynchronization snapshots remain
on the system.) Issue either of the following commands:
# stoprcopygroup
where represents the name of the primary volume group.
or:
# stoprcopygroup -pat
where represents the pattern of volume group names to stop (for example,
Group*
).
2. Change the mode of the volume group by issuing either of the following commands:
# setrcopygroup mode
where:
•
—New remote-copy mode (sync or periodic)
•
—Name of the backup system for the volume group you are changing
•
—Name of the primary volume group
or:
# setrcopygroup mode -pat
114 Working with Volume Groups