HP 3PAR Operating System Software User Manual
Page 283
consistency groups
configuring the synchronization period,
loss of sync between,
synchronization of new consistency groups,
controller node ports, install and configure,
,
controller nodes,
in 1-to-N configuration,
in N-to-1 configuration,
in SLD configuration,
interface,
controlport
CLI command,
,
,
,
controlport command
controlport rcfc,
conventions
text symbols,
CPG,
allocation limit,
assigning VV to,
creating,
local and remote,
maximum volumes,
setting local and remote,
space allocation,
unsetting,
volume autocreation,
CPVV see FPVV
creatercopygroup
CLI command,
,
creatercopytarget
CLI command,
,
,
createsv
CLI command,
createvv
CLI command,
creating
a quorum,
target volumes on secondary system,
D
data
concurrency,
flow, natural direction,
replication method,
data flow
changing,
in 1-to-1 non-disruptive failover,
in SLD disaster recovery,
in unidirectional 1-to-N disaster recovery,
in unidirectional N-to-1 disaster recovery,
deleting
target volumes,
disaster recovery
bidirectional,
location of primary and backup storage systems,
SLD,
dismissrcopylink
CLI command,
dismissrcopytarget
CLI command,
dismissrcopyvv
CLI command,
,
,
documentation
providing feedback on,
E
error
during I/O service start,
errors
all-link failure,
contacting target system,
handling,
read,
single-link failure,
storage-system failure,
target failure,
timeout,
write,
F
failover,
,
asynchronous periodic backup system,
asynchronous periodic mode,
automatic transparent,
non-disruptive,
policy,
system information,
troubleshooting,
with data transfer,
failure
backup system,
primary system,
scenarios,
failures
backup system,
command failure due to no mirror config,
complete network failure,
network failure (disaster recovery),
primary storage system,
read errors,
read request failure,
single link,
,
storage system,
write errors,
FC
connections,
network,
SAN,
FCIP
M-to-N,
routers,
vs RCIP,
firewall
port setting,
283