HP 3PAR Operating System Software - Manual (Page 188)

remotevv.2 23 localvv.0 385 Synced Thu Dec 14 18:23:45 PST 2006
remotevv.3 24 localvv.1 386 Synced Thu Dec 14 18:23:44 PST 2006
c. Issue the showrcopy command on the recovered system (System2).
d. Verify the following:
•
The Status of the target system (System1) is ready
•
The Status of all sending links is Up
•
The Role of the synchronizing volume groups is Secondary-Rev
•
the SyncStatus of all volumes in the Secondary-Rev volume groups is Syncing
The following example shows the showrcopy command output for System2:
# showrcopy
Remote Copy System Information
Status: Started, Normal
Target Information
Name ID Type Status Options Policy
System1 11 IP ready mirror_config
Link Information
Target Node Address Status Options
System1 0 10.100.33.63 Up
System1 1 10.101.33.63 Up
receive 0 10.100.33.63 Up
receive 1 10.101.33.63 Up
Group Information
Name Target Status Role Mode Options
periodic_group_1 System1 Started Secondary-Rev Periodic Last-Sync Thu Dec 14 18:19:17
PST 2006 , over_per_alert
LocalVV ID RemoteVV ID SyncStatus LastSyncTime
localvv.0 413 remotevv.0 21 Syncing Thu Dec 14 18:40:14 PST 2006
localvv.1 414 remotevv.1 22 Syncing Thu Dec 14 18:39:03 PST 2006
Solution Problem
I/O to the volumes on the
failover system did not stop
before the synchronization. 1. Stop I/O.
2. Manually synchronize the remote-copy pair. On the failover system (System1),
enter either of the following commands:
syncrcopy
where represents the reversed volume group
(periodic_group_1.r96)
or:
syncrcopy -pat
where -pat represents the pattern of reversed volume group
names (periodic*)
188 Disaster Recovery for M-to-N Configurations