HP 3PAR Operating System Software - Manual (Page 256)

Table 10 Quick Setup Steps for Unidirectional Pairs: 1-to-1, N-to-1, and 1-to-N Configurations
(continued)
Backup System Primary System Reference Step
•
If synchronizing directly
from system to system: startrcopygroup “Starting Initial Replication
for Unidirectional Remote
Copy: Copying Data
Directly from Primary Volume
Groups” (page 84)
showrcopy showrcopy 11. Verify synchronization.
Quick Setup: Bidirectional Remote Copy
Table 11 Quick Setup Steps for the Bidirectional Pair: 1-to-1, N-to-1, and 1-to-N Configurations
Backup System Primary System Reference Step
— showrcopy “Setting Up the Systems for
Bidirectional Remote Copy”
(page 88) 1. Verify that a
unidirectional remote
copy pair is set up.
— showrcopy “Verifying That Virtual
Volumes Are Created for 2. Verify that virtual volumes
exist.
Unidirectional Remote
Copy” (page 81)
creatercopygroup
:
— “Creating Volume Groups
for Bidirectional Remote
Copy” (page 88) 3. Create primary volume
groups.
setrcopygroup period
s|m|h|d
— “ 4. (Optional, asynchronous
periodic mode only) Set
up automatic
synchronization.
admitrcopyvv — “ 5. Add the virtual volumes
to their volume groups.
— — “Selecting an Initial
Synchronization Method for 6. Decide the method to use
for the first replication of
data.
Bidirectional Remote Copy”
(page 90)
— — “Using Tape for Initial
Synchronization and
Backup” (page 151) •
If using tape for data
transfer:
startrcopygroup — “Starting Initial
Synchronization for
Bidirectional Remote Copy: • If synchronizing directly
from system to system:
Copying Data Directly from
Primary Volume Groups”
(page 91)
showrcopy showrcopy “ 7. Verify synchronization.
256 Quick Setup Guide