HP Insight Control Software for Linux - Manual (Page 55)

5.3.4 Copying virtual machine OS into the repository
The procedure for copying virtual machine OS into the repository depends on the virtual machine
software:
•
For VMware ESX, the process is identical to copying a RHEL operating system to the repository.
For more information, see
“Copying software to the Insight Control for Linux repository”
(page 51) .
•
For VMware ESXi, copy the contents of the media to the
/opt/repository/boot/vm_nameBoot
directory, where vm_name is the name of the
directory for the VMware ESXi virtual machine OS.For example, for ESXi version 4.0, the
directory would be /opt/repository/boot/ESXi4.0Boot.
Data for VMware ESXi is not transferred through HTTP; instead, it is loaded from the
/opt/repository/boot/vm_nameBoot
directory using PXE or virtual media.
•
For Xen, no additional action is required because the RHEL or SLES distribution accounts for
it.
5.3.5 Copying a custom OS into the repository
The Insight Control for Linux installation tools enable the installation of almost any OS that supports
either the PXE boot protocol or virtual media and provides kernel and RAM disk files that contain
the drivers for the target managed system installed.
Similar to the process for copying the vendor-supplied installation files for a supported OS, you
copy the installation sources to the Path on disk and copy the kernel and RAM disk files to the Boot
target path on disk that custom OS registration process supplied to you.
5.3.6 Automating a custom OS installation
HP recognizes that different versions of Linux have different installation configuration files (for
example RHEL distributions have
Kickstart files while SLES distributions have AutoYaST files) and
that different Linux distributions accept different kernel parameters in the boot loader configuration
file. You can now control this content by using special scripts; Insight Control for Linux calls these
scripts at various points when your custom OS installation runs. You can find example scripts for
CentOS and Debian installations under the /opt/repository/instconfig/custom/
examples
directory.
NOTE: If you want to perform an automated custom OS installation (for a custom OS that was
registered with the repository in a version of Insight Control for Linux before V6.0), you must create
the /opt/repository/instconfig/custom/OS_Name directory manually.
Insight Control for Linux automatically creates this directory when a custom OS is registered with
the repository. However, in versions of Insight Control for Linux before V6.0, automated custom
OS installations were not supported; that directory would not exist.
For full information on custom OS installations using Insight Control for Linux, see the white paper
titled Installing a Custom Operating System with HP Insight Control for Linux.
5.3.7 Copying or downloading PSPs into the repository
You can either copy a partial PSP, which is packaged with HP SIM, or download a complete PSP.
Copying a PSP from the CMS
To copy a PSP:
1.
Locate the PSP by OS type and version from the /var/opt/mx/linuxagents directory.
5.3 Copying software to the Insight Control for Linux repository 55