HP Insight Control Software for Linux - Manual (Page 190)

23 Miscellaneous topics
This chapter addresses the following topics:
•
“Changing management processor credentials” (page 190)
•
“Changing the default port for the repository web server” (page 190)
•
“Increasing the number of servers that can be discovered concurrently” (page 191)
•
“Changing the IP address of the CMS ” (page 191)
•
“Uninstalling Insight Control for Linux” (page 191)
•
“Determining the installed Insight Control for Linux version” (page 192)
•
“Event logging overview” (page 192)
•
“Changing the number of concurrent tasks” (page 193)
•
“Support for HP ProLiant DL1xx series servers” (page 194)
•
“Setting up the DHCP server for virtual guests” (page 194)
•
“Uninstalling atftp and installing tftp” (page 195)
23.1 Changing management processor credentials
Select the following menu item from the Insight Control user interface to change the user name and
passwords for
iLO -based management processors:
Configure
→Management Processor→Credentials
You can set these credentials at a global level for all managed system s or set them on an individual
basis.
If you want unique credentials on an LO100-based server, you must set them manually. The
Configure
→Management Processor→Credentials only sets these credentials locally.
For more information on management processor credentials, see “Management Processor
Credentials” (page 196) .
23.2 Changing the default port for the repository web server
By default, the repository web server is configured to provide files on TCP port 60000.
NOTE: The default port for the repository web server is hard coded in the VMware ESX Kickstart
template files. If you want to change the port, you must manually replace all occurrences of 60000
with the new port number before performing the VMware ESX installation.
To change the default port, follow these steps:
1.
Use a text editor to edit the following file:
/opt/mx/icle/icle.properties
2. Change the value of the REPOSITORY_HTTP_PORT attribute to an unused port that is available
and selected to run the repository web server.
3. Save your changes and exit the text editor.
4. If you have changed the port number for the repository web server, verify that the new port
is open on the CMS. One method is to use the nmap command.
5. Restart HP SIM by running the following commands:
# /opt/mx/bin/mxstop
# /opt/mx/bin/mxstart
Wait for two to three minutes for HP SIM to restart completely.
190 Miscellaneous topics