KYORITSU 6315 Instruction Manual User Manual
Page 71
Filter setting for Flicker measurement
KEW6315
- 69 -
KEW6315
Filter setting for Flicker measurement
“Filter coefficient”
Set a proper filter coefficient according to the nominal voltage for accurate flicker measurements. Select
the values of nominal voltage, nominal frequency and filter coefficient values appropriate to the actual
measured object. If possible, harmonize the filter coefficient and the nominal voltage.
Selection
230V/ 220V/ 120V/ 100V
* Default setting is highlighted in gray.
Move the blue highlight to “Filter”.
Show the pull-down menu.
Select proper Filter coefficient.
Confirm.
Cancel.
See also other documents in the category KYORITSU Tools:
- 1009 (13 pages)
- 1011 (12 pages)
- 1012 (12 pages)
- 1018 (1 page)
- 1030 (1 page)
- 1061 (58 pages)
- 1051 (40 pages)
- 1109S (36 pages)
- 1110 (1 page)
- 2000 (1 page)
- 2002PA (27 pages)
- 2007A (1 page)
- 2009R (33 pages)
- 2012R (2 pages)
- 2017 (1 page)
- 2031 (1 page)
- 2033 (9 pages)
- 2040 (2 pages)
- 2046R (2 pages)
- 2200 (3 pages)
- 2210R (1 page)
- 2300R (1 page)
- 2413F (24 pages)
- 2413R (24 pages)
- 2431 (2 pages)
- 2432 (1 page)
- 2433R (1 page)
- 2434 (10 pages)
- 2500 (1 page)
- 2608A (2 pages)
- 3005A (24 pages)
- 3021 (24 pages)
- 3121A (12 pages)
- 3126 (28 pages)
- 3127 (60 pages)
- 3128 (88 pages)
- 3131A (20 pages)
- 3132A (20 pages)
- 3161A (24 pages)
- 3321A (24 pages)
- 4105A (10 pages)
- 4106 (48 pages)
- 4116A (20 pages)
- 4140 (32 pages)
- 4200 (24 pages)