KYORITSU 6315 Instruction Manual - Manual (Page 17)

1.4 Steps for measurement KEW6315
- 15 - KEW6315
1.4 Steps for measurement
Read through the operating instructions described in “ Safety
warnings ” (P.8) before starting to use the instrument.
Preparation
Chap. 4: Getting started (P.27)
Cord and Sensor Connection
Clause 4.4: Voltage test leads and Clamp sensor connection (P.35)
Turning on the instrument.
Clause 4.5: Start KEW6315 (P.36)
Making basic settings.
Clause 5.2: Basic setting (P.48)
Reading the setup data
Clause 5.6: Saved data (P.82)
Wiring
Clause 5.2: Basic setting – Wiring (P.51)
Wiring check
Clause 6.4: Vector (P.105)
Advanced setting and data save method
Clause 5.3: Measurement setting (P.59)/ 5.4: Recording setting (P.71)
Confirming the measured values.
Clause 6.1: Inst value [W] (P.92)/ 6.4: Vector (P.105)
Start/ stop recording
Clause 4.6: Recording procedures (P.37)
Confirming the measured data.
Chap. 6: Displayed items (P.92)
Disconnect the cords and sensors from the measurement line, and turn off
the instrument.
Data analysis on PC
Clause 8.1: Data transfer to PC (P.125)
Chap. 9: PC software for setting and data analysis (P.129)