KYORITSU 6315 Instruction Manual - Manual (Page 112)

KEW6315
KEW6315 - 110
e.g.) 3P4W (Three-phase 4-wire) : with “LOG” and
Items displayed on the graph
Exceeding
the axis value
Displayed when the rate of harmonics content of each order is more than 10%.
The rate of harmonics content of the 1st basic waveform is “100%”, therefore,
always exceeding the axis value in “LOG” display.
Max value
Max values recorded during measurements are displayed. These values can be
reset any of the following methods.
* Setting change,
* Start of recording, or
* Long press (2 sec or longer) of
Graph color
When multiple measurement channels are used, each graph is displayed in
different colors.
Exceeding the
threshold
Displayed when measured values exceed the preset allowable range.
Allowable range
Preset by default and complied with
To change the range, select “Edit allowable range.” in the “Measurement” setting
Exceeding the
axis value
Max value
Graph color
Displaying harmonics on the bar graph
110 -
and “Zoom”.
Items displayed on the graph
rate of harmonics content of each order is more than 10%.
The rate of harmonics content of the 1st basic waveform is “100%”, therefore,
always exceeding the axis value in “LOG” display.
Max values recorded during measurements are displayed. These values can be
reset any of the following methods.
* Long press (2 sec or longer) of Key.
When multiple measurement channels are used, each graph is displayed in
Displayed when measured values exceed the preset allowable range.
Preset by default and complied with IEC61000-2-4 Class3.
To change the range, select “Edit allowable range.” in the “Measurement” setting.
Exceeding the
threshold
Allowable
range