KYORITSU 6315 Instruction Manual - Manual (Page 38)

KEW6315
KEW6315 - 36
4.5 Start KEW6315
Start-up Screen
Hold down the POWER key until the following screen is displayed on the LCD. To power off the
instrument, hold down the POWER key at least 2 seconds.
1 Model name and software version will be displayed upon powering on the instrument.
Stop using the instrument if it does not get started properly, and refer to
(P.157) in this instruction manual.
2 If this is not the first time starting the instrument, the screen displayed last
operation will appear.
Cautionary message
If the connected Clamp sensors are not the same
of the connected sensors will be displayed for 5 sec; but the settings will not be updated
automatically. Press the key and re
KEW6315 retains and adopts the previous settings
Start-up Screen
36 -
the following screen is displayed on the LCD. To power off the
at least 2 seconds.
Model name and software version will be displayed upon powering on the instrument.
started properly, and refer to “Chap. 11 Troubleshooting”
the instrument, the screen displayed last from the previous
If the connected Clamp sensors are not the same ones used during the previous test, the list
rs will be displayed for 5 sec; but the settings will not be updated
and re-detect the sensors or modify the settings directly.
the previous settings if no sensor is connected.