Inspection cycle – KYORITSU 6315 Instruction Manual User Manual
Page 63
Settings of demand measurement
KEW6315
- 61 -
KEW6315
”Inspection cycle”
The buzzer sounds when the predicted value exceeds the target value within the selected inspection cycle.
The inspection cycle should be shorter than the demand measurement cycle. The relations between the
measurement and inspection cycles are as follows.
* Default value is highlighted in gray.
Move the blue highlight to “Inspection”.
Show the value entry window.*
Select a desirable time.
Confirm.
Cancel.
Measurement cycle
Inspection cycle
10 min/ 15 min
1 min/ 2 min/ 5 min
30 min
1 min/ 2 min/ 5 min/ 10 min/ 15 min
* A pop-up appears and show the effective range.
See also other documents in the category KYORITSU Tools:
- 1009 (13 pages)
- 1011 (12 pages)
- 1012 (12 pages)
- 1018 (1 page)
- 1030 (1 page)
- 1061 (58 pages)
- 1051 (40 pages)
- 1109S (36 pages)
- 1110 (1 page)
- 2000 (1 page)
- 2002PA (27 pages)
- 2007A (1 page)
- 2009R (33 pages)
- 2012R (2 pages)
- 2017 (1 page)
- 2031 (1 page)
- 2033 (9 pages)
- 2040 (2 pages)
- 2046R (2 pages)
- 2200 (3 pages)
- 2210R (1 page)
- 2300R (1 page)
- 2413F (24 pages)
- 2413R (24 pages)
- 2431 (2 pages)
- 2432 (1 page)
- 2433R (1 page)
- 2434 (10 pages)
- 2500 (1 page)
- 2608A (2 pages)
- 3005A (24 pages)
- 3021 (24 pages)
- 3121A (12 pages)
- 3126 (28 pages)
- 3127 (60 pages)
- 3128 (88 pages)
- 3131A (20 pages)
- 3132A (20 pages)
- 3161A (24 pages)
- 3321A (24 pages)
- 4105A (10 pages)
- 4106 (48 pages)
- 4116A (20 pages)
- 4140 (32 pages)
- 4200 (24 pages)