KYORITSU 6315 Instruction Manual - Manual (Page 60)

KEW6315 Settings of External input terminal/ reference frequency
KEW6315 - 58 -
Settings of External input terminal/ reference frequency
”DC Range”
Select a proper DC range according to the incoming DC voltage signals.
Selection
100mV/ 1000mV/ 10V
* Default setting is highlighted in gray.
Move the blue highlight to “DC Range”. Show the pull-down menu.
Select a proper range. Confirm. Cancel.
”Frequency”
Choose the nominal frequency of the system to be measured. If it is difficult to specify the voltage frequency,
for example, in the event of power interruption, KEW6315 performs measurements based on the preset
nominal frequency.
Selection
50Hz/ 60Hz
* Default setting is highlighted in gray.
Move the blue highlight to “Nominal f”. Show the pull-down menu.
Choose the frequency. Confirm. Cancel.