GW Instek GDM-8261 User Manual - Manual (Page 88)

GDM-8261 User Manual
88
The diagram below shows how the total offset is
obtained.
Buffer
Hi
Total offset
A/D
Driver
ADC
Lo
ADC
offset
A/D Driver
offset
Buffer
offset
Input Hi
Terminal
Input Lo
Terminal
Applicable
Measurement
Mode, Rate and
Speed settings Mode Rate Accuracy Speed Quick Speed
DCV,
DCI,
4W/2W S  
M 
F 
TC, RTD  (No Speed setting)
Panel operation 1. Press the Shift key followed by
the 2nd (Menu) key. Press the
right key twice. The ADC
setting menu appears.
/ EXIT SHIFT
2ND
MENU
TRIG TRIG
2. Press the Down key twice. The
A-Zero setting appears.
1st display Shows A-Zero setting
3. Select the setting using the
Up/Down key.
4. Press the Enter key to confirm
your selection. Press the Exit
key to go back to the default
display.
AUTO
ENTER
/ EXIT SHIFT