GW Instek GDM-8261 User Manual - Manual (Page 145)

REMOTE CONTROL
145
8. Press the Exit key to exit from
the configuration menu.
/ EXIT SHIFT
2. Subnet
Configuration 1. Press the Shift key, the 2nd
(Menu) key, and the Left key
repeatedly until the SET LAN
configuration menu appears.
Note: SET LAN will only be
available after LAN has been
activated in the I/O menu, see
page 139.
/ EXIT SHIFT
2ND
MENU
HOLD
2. Press the Down key and the
Right key repeatedly until the
SUBNET selection display
appears.
Note: The subnet mask can only
be edited if DHCP is off.
TRIG
3. Press the Down key. The
SUBNET address selection
appears.
S1 S4 S2 S3
The subnet address is divided in 4 groups;
S1:S2:S3:S4. The cursor will be flashing on S1
(indicated by ―X‖).