Connect wires – GW Instek GDM-8261 User Manual User Manual

Page 105

SCANNER (OPTIONAL)

105

Enable scanner
(Jumper J9)

Set the jumper J9 on the rear side of the board
accordingly. Move the jumper up (pins 3-2) to disable the

scanner, and down (pins 2-1) to enable the scanner.

3
2
1

3 2 1

3 2

Enabled

Disabled

Connect Wires

Wire selection

Make sure the wires have at least the same voltage and
current capacity as the maximum ratings of the

measurement.

Connection

1. Turn the screw left (loose) using a screw driver and

insert the wire. Turn the screw right (tighten) and

secure the connection.

Tighten

Loosen

Insert