Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 54)

Survey Pro Reference Manual
R-46
; Design Elevation from Offset Segment : Determines where the
cut/fill value is computed from in the Offset and Road Stakeout
screens when the Offset checkbox is checked and a non-zero offset is
entered. When checked, the cut/fill value is calculated from the design
elevation of the node you are staking to. When unchecked, the cut/fill
value is calculated from the design elevation at the specified offset
location.
Note: If the specified offset extends beyond the end of the road
profile, the cut/fill value is always computed from the design
elevation of the node you are staking to.
; Write Cut Sheet Data Only (No Store Point) : When checked, as-
built points are not stored to the JOB file when staking points; only
the raw data is written to the RAW file.
; View from Gun to Rod (non-remote) : When checked, the move
left or right information will be presented from the rod person’s point
of view. When unchecked it will be presented from the total station’s
point of view. (This option only applies when a robotic total station is
selected in the Instrument Settings.)
; View from Rod to Gun (remote) : When checked, the move left or
right information will be presented from the rod person’s point of
view. When unchecked it will be presented from the total station’s
point of view. (This option only applies when a non-robot total station
is selected in the Instrument Settings.)
; Prompt for Layer : When checked, a prompt to select a layer will
appear before any new point is stored from only the routines under
the Stakeout menu.
; Prompt for Attributes : When checked, a prompt to select feature
information will appear before any new point is stored from only the
routines under the Stakeout menu. This also requires that a feature
file be selected from the Files Settings card, described earlier.
Note: There is no Prompt for Description checkbox as in the Surveying
Settings card because you are always prompted for a description
when storing a point from a stakeout routine.