Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 208)

Survey Pro Reference Manual
R-200
Base Setup
Survey Base Setup .
The Current GPS Base screen displays the position of the current
RTK base reference position used by Survey Pro. It can be used to
open the Base Setup wizard, which can set an RTK base receiver to
begin broadcasting differential corrections, and configure the base
reference position in Survey Pro
When you tap the Base Setup menu item, the Current
GPS Base Station information screen is displayed.
Base Point : displays the current base point name, if set.
• Latitude: displays the current latitude of the
base point set in Survey Pro.
• Longitude: displays the current longitude of the
base point set in Survey Pro.
• Height: displays the current height of the base
point set in Survey Pro.
Antenna : displays information about the antenna if it is
available.
Set New Base : prompts you to choose a base receiver to
connect to, and opens the Base Setup wizard where you
can set the RTK base and configure the base reference position in
Survey Pro. The Base Setup wizard is described as part of the Start
GPS Survey wizard (Page R-179).
Clear : clears the existing base setup. This is usually not done, but
may be required if you wish to edit the base point using the Edit
Points screen from the Job menu. You will have to reset the RTK base
and rover in Survey Pro before you collect more data.