Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 292)

Survey Pro Reference Manual
R-284
X-Slope (%): is the slope of the selected road section.
1/2 Road Width: displays the width of the selected road section
defined in the previous screen. This value can quickly be edited from
this field.
: opens the Smart Target options (Page R-444).
Backsight… : accesses the Backsight Setup screen (Page R-114).
< Back : returns to the previous screen.
Solve > : accesses the next screen.
Offset Staking – Screen Four
The fourth Offset Staking screen displays the information needed to
aim the total station toward the selected design point.
Station: displays the current station and section of the
roadway being staked and the current line segment type
from the polyline that describes the centerline. If
staking the center and an offset was specified, (To L) or
(To R) is also displayed to indicate if the offset is to the
left or right of the centerline, respectively.
Offset: displays the offset that is applied to the design
point.
Slope: displays the slope of the road at the section being
staked.
From Gun to Design Point: displays the angle and
distance information from the total station to the design
point (plus offset if specified).
Circle Zero : is used to modify the circle on the total
station so that the angle right reading will be zero when it is facing
the current target, which can sometimes be easier than turning to an
obscure angle value. When this button is tapped, the following
actions will occur:
1. A new backsight circle value is computed, sent to the instrument
and stored in the raw data