Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 159)

Survey Menu
R-151
Check Point
Survey Check Point .
The Check Point screen compares the rod location with an existing
point in the project. This routine is similar to the Check Backsight
routine (Page 117) and is used to verify that the rod and/or the total
station is over the correct point. This routine does not store a new
point.
Point: is the point from the project that will be compared
to the observed point (rod location).
Height of Rod: is the length of the rod.
Backsight… : accesses the Backsight Setup screen (Page
R-114).
Take Shot : takes a shot and displays the deltas between
the observed point and the selected point. High delta
values can indicate either the rod and/or total station is
over the wrong point. The deltas can also be viewed in
the Results screen and Map screen.
: is a shortcut to the Surveying Settings screen (Page
R-44).