Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 107)

Job Menu – GPS Module
R-99
IP Modem Settings Screen
The IP Modem Settings screen is used to create or modify an IP
modem configuration. (You can only configure in IP modem when
RTK Rover
is selected for the receiver.)
IP Address of Base : is the IP address of the base.
Port (Socket) of Base
: is the socket number of the base.
Use Advanced Settings : When checked, allows you to
specify alternate Hayes AT commands to connect and
disconnect. When unchecked, the default connect
command of ate0&d0dt and disconnect command of
ath0
will be used.
Connection Command : is the alternate Hayes AT
command used to connect.
Disconnect Command : is the alternate Hayes AT
command used to disconnect.
General Settings
The General Settings card is used to configure settings specific to
each brand and model. Models which have special settings available
are described below.
Settings For Trimble Receivers:
Store post process file to : is where you choose the location of the
post processing file. Choices are:
• Receiver
memory
• Data Collector
Note: This setting is only available when your receiver model is
5700, 5800, R7, R8.