Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 173)

Survey Menu
R-165
GeoLock Settings
Survey Remote Control Settings
or Job Settings GeoLock .
The GeoLock Settings screen is used to enable/disable GeoLock and
configure the receiver communication settings.
Enable GeoLock: When checked, enables the GeoLock
feature.
Model: Select Holux from the dropdown list if using a
Holux or other CompactFlash GPS receiver. (The
remaining communication settings will be hidden.)
Select Generic NMEA if communicating with any other
brand GPS receiver that sends NMEA data.
Serial Port: is the serial port on the data collector used
to communicate with the GPS receiver. Select Bluetooth
if communicating with Bluetooth.
Bluetooth… : (Available only when using a Bluetooth
GPS receiver and Bluetooth is selected for the Serial
Port.) accesses the Bluetooth configuration screen that
comes with the Bluetooth driver software where you can
quickly check or change the virtual COM port and favorites. See the
User’s Manual for more information on configuring Bluetooth.
Baud Rate: is the speed that communication takes place. This must
match the baud rate set in the GPS receiver.
Parity: This must match the parity set in the GPS receiver – usually
None.
Use 3D GeoLock…: When checked, the GPS elevation will also be
used to compute your location and adjust the vertical angle of the
total station accordingly. GPS is generally less precise vertically than
horizontally so unless you are using GeoLock while in very steep
terrain, this item should remain unchecked.