Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 251)

Survey Menu – Basic GPS Module
R-243
Base/Rover Receiver : displays information about the status of the
receiver.
Measured To : specifies the location on the antenna or receiver where
the antenna height should be measured to.
Measured
: The distance from the ground to the Measured To
location.
Serial # : is the serial number of the antenna. This information is
optional and written as a note in the raw data.
Next > : opens the next screen, which depends on the type of receiver
you are connected to and at what stage in the Start GPS Survey
routine you are at.
Start Survey – One Matching Base
Point
This screen will open when the base is set up on a point
that potentially matches only one point in the job.
Change > : opens the Next > : opens the Set Up Rover
screen.
Start Survey – No Matching Base screen (Page R-244)
where the base point can be redefined before continuing.
Next > : opens the Set Up Rover screen.