Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 206)

Survey Pro Reference Manual
R-198
Store point in
: is used to select how to store this session. You will
always get a session recorded in the post processing log file. Select
Receiver and job file
to store a point record in the Survey Pro .JOB file
as well. By default, post processing points will go on the layer
selected on the Job | Settings | Post Process screen.
Note: If you are using this screen with the RTK rover, you can only
store points in the post processing log file from this screen. Use the
RTK Data Collection screen to store points in Survey Pro
simultaneously with points logged to the post processing file.
Point (or) Site ID : is where you enter the station name for the static
session or stop and go point.
Note: If you are storing this point in Survey Pro, the screen will look
like the picture above, and you can pick points using the Survey Pro
compound point control. If you choose an existing point, you will be
prompted to rename or overwrite, just like RTK data collection. If
you are storing this point in the receiver file only, then the point
control is replaced with a simple edit box. When storing to receiver
only, you can reuse an existing point name without modifying that
point in the Survey Pro job file.
Description : is where you enter the description for the static session
or stop and go point.
Log Until Stop : is where you select to use a Duration or to record until
Stop is tapped.
Duration : is where you enter the session length for the next
occupation.
Set HR : displays the current antenna measurement and measure to
setting. You can change the antenna measurement by entering a new
value in the edit box. This new antenna height will be sent to the
receiver with your next control or check point collection. You can
change both the antenna measurement and measure to setting by
tapping on Set HR to open the Receiver Antenna screen (Page R-181).