Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 195)

Survey Menu – GPS Module
R-187
Data Collection
Survey Data Collection .
The Data Collection screen is used to collect GPS measurements and
store new points in the job.
GPS Status : displays the current solution type, the data
modem reception quality, the number of satellites used
and the horizontal precision computed by the receiver.
When this area is tapped, the GPS Status screen (Page
R-168) will open.
Point : is where you enter the point name for the next
point to be stored.
Description : is where you enter the description for the
next point to be stored.
Set HR : displays the current antenna measurement and
measure to setting. You can change the antenna
measurement by entering a new value in the edit box.
This new antenna height will be sent to the receiver with
your next data collection point. You can change both the
antenna measurement and measure to setting by tapping on Set HR
to open the Receiver Antenna screen (Page R-181).
Post Process : opens the Receiver Session screen (Page R-197), where
you can occupy a point for a post processing only session. This allows
you log a session in the post processing file using an existing point
name without changing that point record in the job file.
Control : opens the Control Points screen (Page R-192).
Topo SS : stores a point with a single epoch of data. The current
position is checked against the criteria, and if acceptable, the point is
stored.
Note: The Topo SS function never puts the receiver in static mode, so
the precision of the rapid side shot will be less than a point occupied
in static mode.