Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 294)

Survey Pro Reference Manual
R-286
Change… : is used to modify the current design elevation, which will
also modify the associated CUT/FILL value for the current station
being staked.
Shot : takes a shot to the prism and computes come/go, cut/fill
information.
Shot data: displays the measurements from the last shot.
Store… : opens the next screen.
Store/Tape… : accesses the Stake Out Point (Tape Offset) dialog box
(Page R-305), where the staked point can be stored that includes a
specified offset. The default value is the appropriate distance
correction to the design point.
Topo SS… : stores a side shot using the data from the last shot
taken. (This will not take a new shot.)
Turn Gun : (available with robotic total station) turns the total
station toward the design point.
< Back : returns to the previous screen.
Stake Next > : returns you to the second Offset Staking screen,
without storing a stake point, where the Design point is advanced by
the Increment value.
Offset Staking – Screen Six
This screen is used to describe the stake point before it is
stored and select if the Results screen should be
displayed (described next).
Point: is the point name for the stake point being stored.
Description: is the description for the stake point being
stored. The default description is the station, side, and
distance from the centerline for the design point.
Show Results on OK: When this checkbox is checked, a
Results screen (described next) will open after tapping
from this screen.