Spectra Precision Survey Pro v4.5 Recon and Nomad Reference Manual - Manual (Page 252)

Survey Pro Reference Manual
R-244
Start Survey – More than One
Matching Base Point
This screen will open when the base is set up on a point that
potentially matches more than one point in the job.
Change > : opens the Next > : opens the Set Up Rover
screen.
Start Survey – No Matching Base screen (Page R-244)
where the base point can be redefined before continuing.
Select a Base Point
: allows you to choose a point from
the dropdown list, which contains all the matching
points found in the job.
Next > : opens the Set Up Rover screen.
Start Survey – No Matching Base
Point
This screen will open when the base is set up on a point
that does not match any point in the job.
Base is set on a new job point
: Select this if the base is
set up on a point that is not already stored in the job.
The next screen will then require that you connect to the
rover receiver and occupy control points to perform a
resection for the base position.
Base is set on an existing job point : Select this when
the base is set up on a point stored in the job.
Base Point : specifies the name of the base point. This is
a new point name when the base is set on a new point or